Acta Metallurgica Sinica (English Letters) ›› 2014, Vol. 27 ›› Issue (1): 47-54.DOI: 10.1007/s40195-013-0016-0

• research-article • Previous Articles     Next Articles

Mechanical and Electrical Properties of the Ternary Ag–Sb–Zn System

M. Premović1, D. Minić1, D. Manasijević2, Vladan Ćosović3(), D. Živković2, I. Dervišević1, N. Talijan3   

  1. 1. Faculty of Technical Science, University in Pri?tina, Kosovska Mitrovica, Serbia
    2. Technical Faculty, University of Belgrade, Bor, Serbia
    3. Institute of Chemistry, Technology and Metallurgy, University of Belgrade, Belgrade, Serbia
  • Received:2013-05-08 Revised:2013-07-25 Online:2014-02-25 Published:2014-03-11

Abstract:

This paper presents comparative review of experimental and thermodynamic assessment of ternary Ag–Sb–Zn system. Isothermal section of the Ag–Sb–Zn system at 300 °C has been calculated by CALPHAD method using thermodynamic parameters from literature. Microstructural analysis of a number of alloys was carried out by scanning electron microscopy and optical microscopy, whereas chemical composition of observed phases was analyzed using energy-dispersive X-ray spectroscopy. Hardness of selected alloys from four vertical sections was determined using Brinell hardness test and additionally by micro Vickers hardness test. Electrical conductivity of a number of alloys in the ternary Ag–Sb–Zn system was experimentally determined. Good overall agreement between experimental and calculated values was obtained.

Key words: Ag–Sb–Zn system, Isothermal section, Microstructure, Brinell hardness, Micro Vickers hardness, Electrical conductivity