Abstract: Mechanical alloying (MA), a solid-state powder processing method, is a "far from equilibrium" synthesis technique which allows development of novel crystal structures and microstructures, leading to enhanced physical and mechanical properties. The ability to synthesize a variety of alloy phases including supersaturated solid solutions, nanocrystalline structures, amorphous phases and intermetallic compounds themselves is discussed. No extension of solubility using MA has been observed in the intermetallics studied. Nanostructured grains were observed in all compositions. Long time milling generally resulted in amorphous phase formation in large part because of the increase in grain boundary energy/mole with reduced grain size; good agreement with the Miedema model for amorphization was obtained in the Al-Fe system. Generally an anneal was required to form the intermetallic after MA; however,intermetallics with a large negative enthalpy of formation were detected in the MA condition. A study of the hot isostatic pressing of γ-TiAl powders produced by MA demonstrated that full density can be achieved at least 400℃ below the normal temperature required for conventional powder, that is 725℃ or below. Nanometered sized grains (≤100nm)were observed after HIP'ing up to 850℃.

Key words: Intermetallics, mechanical alloying, hot isostatic pressing